Comparison of measured and calculated values of cutting forces in oak wood peripheral milling
The aim of investigations was to determine whether the tested models for calculating forces in wood cutting, set up under strictly controlled laboratory conditions, can yield sufficiently accurate results for predicting wood behavior in real cutting conditions. Tests were carried out on oak wood (Quercus robur). On the basis of measured values for the required cutting power, cutting forces were calculated and used for comparison by applying the method of coefficient (Kršljak’s model) and Axelsson’s model. The analysis indicated that there is not a result, but there is similarity in the curve shape, i.e. changes in measured values are followed by corresponding changes in calculated values. It can be inferred that analyzed models are not suitable for the cutting forces quantification, but could serve for comparing different cutting modes. More accurate modeling of the cutting process requires, besides physical, wood mechanical properties as well.